Individual Tools

 

Chapman MFG Screwdriver bits vs. other screwdriver bits

  • Chapman bits are precision milled to tight tolerances with flat edges, sharp corners and no burrs for snug screw fit  
  • All bits are machined from USA steel and heat treated with a black oxide rust inhibitor finish 
  • Each bit has ear/or ring stops with ball detent to hold the bit securely in our famous midget ratchet, screwdriver handle or spinner
  • Bits have knurled ends for finger tightening and are stamped with the part #
  • Chapman bits are non-magnetic for use on electronics and PC boards 

 

Where's my part?

We have been updating our original part numbering system to make things a lot simpler and straightforward. Because of this, you might notice when ordering new/replacement parts that they are stamped just a little bit differently. This change effects the following  parts: Phillips, SAE hex, and Metric hex screwdriver bits.

To use our Part Number Conversion Chart, click here.